The Other Side of the Bridge… How to Build a Lean-To.

So a few months ago we built an Adirondack style bridge to help us get from behind our house down to our creek more easily.  Just on the other side of the bridge is a flat area where we have the prettiest view of the water below. If you stand very still, it’s so quiet you can hear the water flowing. It’s so peaceful.

 

Kaydeross Creek

 

We decided to take advantage of that spot and create an area where we could hang out and relax. Here’s how it started..

 

Lean to before

 

This is the view from our house before the bridge was built…

 

Lean to before 1

 

So  a lot of clearing had to be done before either the bridge or the lean to could be built. Here is Hubby with the chainsaw…

 

Lean to

 

After it was cleared out and cleaned up, he built the bridge. Then it was time to build the structure.  We decided on a lean to.  A lean-to shelter is a free standing structure with only three walls and a single-pitched roof.  This will give us a great spot to relax and enjoy the view regardless of the weather.

The first thing we needed to do in order to build the lean to was dig the holes for the footings.  The footings are cement piers on which the corners of the structure sit. We used pressure treated lumber but this will help keep the wood from rotting too.

This would be a tough job had it not been for the tractor and post hole digger  we have. We’ve used it on a bunch of projects and I’m sure we’ll use it on many more. It was well worth the investment.

 

lean to footing

 

A little help from Grandpa…

 

lean to footing hole

 

Once the holes were dug, they inserted the tubes to form the cement piers.

 

cement tube

 

To mix the cement, they used Grandpa’s antique cement mixer. It is a 1940’s Rex mixer with a Stover engine and works like a charm. Luckily, Grandpa has all kinds of helpful stuff.

 

cement mixer

 

Grandpa has some old school tricks up his sleeve, too, with the homemade guide built to place the cement in the tube…

 

cement guide

 

Once the cement was dry it was time to build the structure which we used pressure treated lumber to build.

 

Lean to

 

Lean to framed

 

We decided to use a board and batten style on the outside. Board-and-batten siding is an exterior treatment of vertical boards with battens covering the seams. We used corrugated metal roofing.  Here she is…

 

Lean to

 

 

Bridge and Lean to

 

lean to done

 

So it is not quite finished yet. There’s more to come but picture a chilly winter day, sitting by the fire bundled up under a blanket, hot cocoa (or in our case, Irish whiskey) in hand. Can’t wait to hang out and enjoy the new space with family and friends!  I have a special treat planned to break it in which I’ll share next week so stay tuned.

Thanks for stopping by! Happy DIY’ing!

WARM WISHES FOR THE HOLIDAY SEASON (2)

 

 

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *

2 Comments

    1. Hi Dawn! Thanks very much! It is about 10 x 14. I think if I could do it again, though, I would make it 12 x 14 so that it was a bit deeper. Stay tuned for a fall twist on the hangout 🙂